要获得此硕士学位,您必须满足大学通用的所有要求规定,总结在这里。您必须参加足够的教学课程才能使总学分达到 180(包括独立作业)。从讲授的课程(通常 120 学分)中,您必须拥有:

  • - GPA 为 12(相当于 C3 级)
  • - 至少 90 学分,最低 D3 等级
  • - 成绩不低于 F3- 硕士水平至少 90 个学分。

您必须完成至少价值 60 学分的独立工作(通常是项目或论文)D3 级。以上所有内容都可以从为您指定的奖项所修的课程中得到满足,详情如下。

单位:需要180.00,已使用0.00,需要180.00

PGT Masters Generic Regulations Taught Courses

You must take sufficient taught courses to make the total number of credits (including the project) 180 . From the taught courses (normally 120 credits) you must have:

  • - At least 90 credits at a minimum grade of D3.
  • - No grade below F3.
  • - At least 90 credits at Masters level.

Please note these are minimum requirements and your specific named award (details below) may have additional requirements.

· Units: 120.00 required, 0.00 used, 120.00 needed

Achieve 120 credits, minimum grade F3, GPA 12

The courses (not including the project) for which you achieved at least F3 are listed below. You must achieve F3 over 120 credits and achieve a GPA of at least 12 to satisfy the taught stage requirements.

  • · Units: 120.00 required, 0.00 used, 120.00 needed
  • · GPA: 12.000 required, 0.000 completed
  • · GPA: 0.000 completed 90 credits at a minimum grade of D3

90 credits at a minimum grade of D3

Not Satisfied: [0020] Of the courses (not including the project) taken, you must have at least 90 credits at least grade D3.

Units: 90.00 required, 0.00 used, 90.00 needed

90 credits of level-M courses

Not Satisfied: [0030] Of the courses (not including the project) taken, you must have at least 90 credits at level-M.

· Units: 90.00 required, 0.00 used, 90.00 needed

传感器与成像理学硕士

[012612] 要成功完硕士学位,学生必须参加必修和格拉斯哥大学和爱丁堡大学的选修课。·单位:需要180.00,已使用0.00,需要180.00

传感器与成像理学硕士 Comp Cour

 [000010932] 传感器与成像理学硕士学生必须完成格拉斯哥大学的这些课程第一学期。他们还必须在第二学期学习爱丁堡大学的 20 门必修课。传感器与成像理学硕士 Comp Cour

[0010] 传感器与成像理学硕士学生必须完成格拉斯哥大学的这些课程第一学期。他们还必须在第二学期完成爱丁堡大学的 20 个必修学分。·单位:需要30.00,已使用0.00,需要30.00


on the way to be a Electrical Engineer & Designer......